How does it work?
|
|
|
| This section provides a simple guide to the elements making up a typical automation system for gates, garage doors or barrier gates. |
|
|
|
1
Radio
controls
The transmitter is the most commonly used control device for activation of the gate, garage door and barrier.
The transmitter normally has one or more keys (channels) memorised with the commands on the control unit and powered by an internal battery. To operate, the transmitter must be combined with a specific receiver, the latter also equipped with one or more channels to receive signals sent by the transmitter. Several compatible transmitters can be memorised on each receiver. |
 |
| |
portable controls
wall controls
recessed controls
|
|
|
2
Switches and
proximity readers
In addition to the transmitter, the user can activate the automation by means of a key or digital switch or using a proximity reader for transponder cards. |
 |
| |
digital switches
key switches
proximity reader
|
|
|
3
4
Gearmotors for gates, garage doors and barrier gates
The motor acts on the gate, garage door and barrier to enable movement.
It can be single or double, mounted underground (in the case of swing gates) or externally (swing gates, sliding gates and garage doors). |
 |
|
for gates
for garage doors
for barriers
|
|
|
5
Control
units
The control unit contains the electronics for control of the motors used to activate the gate, garage door and barrier.
It can be external, connected to one or two motors, or integrated in the motor itself.
There are different types of control unit, ranging from the simplest versions to the more sophisticated models with advanced functions.
The control unit acquires signals sent from the exterior (e.g. from photocells) and can also incorporate the radio receiver. |
 |
| |
|
|
|
6
7
Safety
devices
Photocells
Photocells are presence detectors to enable obstacle detection within the operating radius of the automation. On detection of an obstacle, the photocells send a pulse signal to the control unit, which blocks automation movement via the motors. These devices guarantee improved safety of automated gates and garage doors with respect to manual versions.
Flashing lights and courtesy lamps
The flashing light is used to indicate all movements of the gate, garage door and barrier gate to increase visibility for those located in the vicinity. |
 |
| |
photocells
flashing lights
courtesy lamps
|
|
