#Products
Built for the Big Room: Gefen and Furman in Stadiums and Large Venues
15 October 2026
A stadium is one building with dozens of audiences. The production truck, the main bowl, a few hundred concourse screens, the clubs, the suites, the press box and the ops center all need the right content at the right moment, and every one of those endpoints needs power that holds up on game day.
That is where Gefen and Furman fit together. Gefen moves the signal across the venue. Furman keeps the electronics behind it protected, sequenced and reachable from anywhere. Spec them together and you own more of the project, with fewer handoffs when something goes sideways at kickoff.
Gefen: Get every feed to every screen
The backbone of a venue design is AV over IP. Instead of a fixed matrix with a hard port count, every source and display becomes a network endpoint, and the switch is the router. Add a concourse, a club or a new sponsor zone next season and you add endpoints, not a new head end.
Gen3 4K HDMI/USB-C KVM over IP (GF-HDK18G-VIP-TX / GF-HDK18G-VIP-RX). The workhorse for venue-wide distribution.
- 4K60 4:4:4 with HDR over standard gigabit LAN, with shielded Cat-5e or better connecting each endpoint to its switch
- Supports 39,900 senders and more than 65,000 total units, with practical system size determined by network bandwidth and switch capacity
- PoE+ (802.3at) at the endpoint, which saves a power run at every concourse receiver
- RS-232, bi-directional IR, USB and audio route independently of video, so operators can control displays and access remote computers over the same network.
- Requires a managed gigabit switch with jumbo frames of at least 8 KB and IGMP snooping; spec that in the bid, not after it. A dedicated AV LAN is recommended.
GF-AVIP-MC Matrix Controller and Syner-G software. The GF-AVIP-MC gives the ops team one place to discover and configure endpoints, route sources, recall presets, and manage video walls through a web interface. Syner-G supports device discovery and initial IP setup during commissioning.
HDBaseT and fiber extension. Not every run belongs on the network. Use point-to-point where it is simpler and cheaper:
- GF-EXT-HD-HBT for 4K60 4:4:4 with HDR, two-way IR and RS-232 over one Cat cable, ideal for a suite or club display off a local rack.
- GF-EXT-UCK-HBT3 for USB-C laptop connections at press-box desks and lecterns, carrying 4K60 video, USB 2.0 and audio to a remote HDMI display, with up to 60W of laptop charging.
- GF-HD48G-1MPO for high-bandwidth HDMI fiber runs up to 100 meters over MPO/MTP multimode fiber, such as production truck to head end or scoreboard control to the bowl when the route falls within that distance.
- GF-EXT-HDK-HBT2 for HDMI KVM over HDBaseT so operators can run a remote PC from the control room with USB, audio and RS-232. For DisplayPort workstations, use GF-EXT-DPK-HBT3.
The design rule: AV over IP between zones, point-to-point or local splitting inside a cluster showing the same content. Hybrid is usually the most economical answer.
Furman: Keep it on, in order, and reachable
A venue's power is about as hostile as it gets: shared transformers, HVAC plants, elevators, LED ribbon boards and concession equipment all dump noise and voltage swings onto the same lines feeding your AV. Furman's job is to make sure none of that reaches the rack, and that the system comes up the same way every event day.
Three technologies ride on nearly every Furman product in a venue spec:
- Series Multi-Stage Protection (SMP): non-sacrificial surge protection that does not degrade with each hit, unlike the MOVs in a standard strip. More than 1,000,000 units shipped with zero surge-related failures.
- Extreme Voltage Shutdown (EVS): cuts power to connected gear when the line goes dangerously high or low, instead of letting the equipment take it.
- Linear Filtering Technology (LiFT): clean power for clean signal. Measured at 97.3% noise reduction through an AC-215A.
Contractor Series CN-2400S SmartSequencer. The head-end and IDF rack standard. 20A, 1RU, six sequenced and two unswitched outlets, with SMP, EVS and LiFT. Sequencing is bidirectional, so amps come up last and go down first: no speaker thump through the bowl, no breaker trip on power-up. Multiple units link over roughly 1,000 feet, so racks across the building can power up as one system from a key switch, contact closure or RS-232.
BlueBOLT remote power management. The feature venue operators remember. Reboot a frozen encoder in a concourse IDF from the control room or from your office, and see power status before anyone calls. On a 70,000-seat building, that is the difference between a fix in two minutes and a tech walking the concourse during the national anthem.
F1500-UPS. 1500VA true sine wave with AVR, RS-232, and IP/BlueBOLT control via the BlueBOLT-CV3 card. Put it under the Gefen controller, network core and anything that corrupts mid-write in a brownout.
Prestige P-2400 AR and P-1800 AR. True RMS voltage regulation for amp racks and any space where line voltage will not hold still. The P-2400 AR handles 20A for halftime-show and touring-production power.
Distributed endpoints. Every display out on the concourse is another load to protect. The CN-20MP puts EVS on a 20A circuit at the display and links to the CN-2400S, so endpoints become part of the same Contractor Series sequence as the rack. The AC-215A brings SMP, EVS and LiFT to a 2-outlet chassis behind a screen or in a suite credenza.
Where each product goes in the building
| Zone | What has to move | Gefen | Furman |
| Head end / control room | Production, broadcast, signage and event feeds | GF-HDK18G-VIP-TX encoders, GF-AVIP-MC controller, GF-EXT-HDK-HBT2 KVM | CN-2400S sequencing, F1500-UPS with BlueBOLT |
| Concourses and IDFs | Signage, menu boards, live game feed | GF-HDK18G-VIP-RX decoders with PoE+ | CN-2400S per IDF rack, CN-20MP at displays |
| Suites and clubs | Game feed plus local sources | GF-EXT-HD-HBT from local rack | AC-215A behind displays and in credenzas |
| Press box and media room | Laptops, lectern PC, broadcast tie-ins | GF-EXT-UCK-HBT3 USB-C KVM extender | CN-2400S or Classic PL-PRO DMC |
| Production truck and long runs | Uncompressed feeds over distance | GF-HD48G-1MPO fiber | P-1800 AR or P-2400 AR for production power |
| Amp and DSP racks | Bowl and concourse audio | Control over IP via RS-232/IR pass-through | CN-2400S linked sequencing, Prestige AR regulation |
Networks, displays, DSPs, speakers, cameras and life safety stay their own dedicated platforms. Name them on the drawing and assign ownership.
Five questions for the first site walk
Before you pick products, walk the venue with these. When two or more answers touch signal and power, stop quoting boxes and start designing the system.
- What content, signals, people or vehicles have to move, and how far?
- What equipment has to stay on and protected, especially on event day?
- Who needs control, and how simple does it have to be for game-day staff?
- What carries operational, security or lifecycle risk if it fails?
- Who owns the network, and which platform stays authoritative?
Then pick the distribution model by scale: point-to-point, local splitting, fixed matrix or AV over IP. Every brand on the BOM should earn its place.
What it means for your business
Signal and power are usually quoted by different people at different times, and the customer inherits the gap. Bring them together and you get a bigger BOM from the same first phone call, a stronger spec story against commodity bids, and one escalation path when the project gets complicated.
The math on power is simple. Proper power management adds roughly 2 to 4% to a system quote. A single avoided callback, about $450 loaded for two techs and half a day, pays for it. On a venue with dozens of racks and hundreds of endpoints, BlueBOLT alone can save more truck rolls in one season than the conditioners cost.
Bring us one venue this quarter. A stadium, arena, amphitheater or convention center where signal and power already overlap. Your Nice rep and an application engineer will walk the five questions with you and build a reference design you can quote again on the next site.
Sources
- Gefen GF-HDK18G-VIP-TX Gen3 KVM over IP
- Gefen GF-AVIP-MC Matrix Controller
- Gefen video extenders
- Furman CN-2400S product page
- Nice North America Gefen reseller briefing and Furman dealer and integrator briefing (internal decks)